This machine use for cut and polish the gemstone and specially designed for Export orders. Able to control the speed from 0 to 3000 rpm from the knob. Could hold the stone hardly even at 50 rpm. Minimum Working Speed is 20 rpm & could increase the speed by 1 rpm till 3000.

Able to control the speed from 0 to 3000 rpm from the knob, Touch display, & remote. Optional controller that not relies on touch system comes free of charge. Could hold the stone hardly even at 50 rpm. Minimum Speed is 25 rpm & could increase the speed by 25rpm till 3000.

This portable faceting machine specially designed for frequent travelers and export orders. Comes with two speeds of 720 rpm and 1440 rpm. While faceting, with reference to the stone hardness, Speed could easily change by moving the belt position from pulley grove.

Both cutters could use both faceting and polishing laps at the same time. Could control the speed and rotation direction with touch display, remote control, & knob. Variable speed control machine comes with optional controller that not relies on the touch system free of charge.

Could use 8 inch or 6 inch lap for faceting and 10 inch or 8 inch or 6 inch lap for polishing. Both cutters could use both faceting and polishing laps at the same time. Table completely made with heavy thick steel plate on the table top and 1.5 inch heavy box iron or L-angle for frame.

Starting from sawing to sanding of a gem stone performed by this combo machine. Required a circular sawing blade and different preforming wheels for each step. Able to control the speed from 0 to 3000 rpm from the knob by 1 rpm deviation. Could hold the stone hardly even at 50 rpm.

Could use a sawing wheel or two preforming wheels that comes with a diamond grit on the outer edge of the wheel. Gemstones are directly hold to the wheel by hand and doesn't required any tool. Normal machine comes with three speeds of 720 rpm, 1440 rpm, and 3000 rpm.

Faceter does not connect to the machine and may quickly be lifted off the table for inspect the progress of work. Faceting methodology consists of cutting appropriate angles on the top and bottom of a gem stone. The cutting angle is adjusted vertically and rotationally.

Gem stone move from one dop stick to another by Transfer Jig accurately after complete the crown or pavilion cut of a gemstone. Dop stick hold the stone, place on one side of the device and glue the gem stone in to another.

Dop sticks use to hold the stone in to faceter. Adhesive wax, epoxy, or glue used to fix the stone in to dop stick. Comes with different sizes and with steel or brass material. Water resistant holder use to keep the dop sticks with or without stones. Leg balancer use to balance the faceter.